For erasing EPROM memory , all data in EPROM can be completely erased in 10 minutes. When using, first remove the light-shielding sticker on the EPROM memory chip . The eraser can erase up to 6 at the same time. Set the timer at 10 minutes and turn on the power. If the erasing is not clean, you can extend the erasing time. Please use the programmer to check the chip programming.Note that the chip is placed with the glass facing upwards. Some manufacturers' will take a long time to erase. Please refer to the chip manufacturer's instructions for details. If the chip is aging, the erasing time will be long or cannot be erased.Drawer structure, drawer size (length, width and height): 95X55X13 millimeters (mm)Built-in ultraviolet lamp, the wavelength of the is less than 400nM (it can be used for the development of some photosensitive materials or the light curing of small prints). The effect is subject to actual use. We cannot promise and .Working voltage: AC 100V-240V.Power requirement : AC 110-220V20%Working Frequency : 43Hz-57HzWorking Temperature: -10C - 40CWorking Humidity: 20%~90% relativePlug Type :EU Plug,it applies to Indonesia, , , , and so on.Colour:As ShownMaterial:plasticPackage Contents:1 x Eprom EraserOnly the above package content, other are not included.Note: Light reflection and different displays may cause the color of the item in the a little different from the real thing. The measurement allowed error is +/- 1-3cm.