Fat Burning Machine EMS Therapy Beauty Device Fat Loss Slimming Massager for Arm Waist Belly Leg Hip Item Type: Fat Burning Machine Instrument Size: Approx. 188 x 78 x 68mm/7.4 x 3.1 x 2.7in (Probe Diameter: Approx. 56mm/2.2in) LED Wavelength: red light: 625±3nm, green light: 525±3nm, blue light: 465±3nm, three color combination light: 592±3nm Mode: Ultrasonic Mode, EMS Mode, Ion Mode, Color Light Mode EMS Mode Strength: 5 Gears Power Supply Type: USB Data Cable Charging Introduction: Red and blue lights flash alternately when charging. It can work for about 1 hour after 2-3 hours of full charge. The charging current is 5V/1A. Battery power is greater than 30% and the blue light is displayed, and the red light is lower than 30%. Automatic shut down. Ion Mode Indication: 1. First, clean remove cosmetics and impurities 2. Take an appropriate amount of cleansing milk and apply it on the face or ultrasonic probe (Note: We recommend that you use fragrance to achieve the best performance when transmitting ultrasonic waves.) Use ultrasonic waves and "lon +" to move slowly for about 2-3 minutes. 3. If you need anti wrinkle, you can apply some anti wrinkle serum on the face or use ultrasonic probe. (Note: We recommend that you use gel serum to achieve the best performance of ultrasonic transmission.) Use ultrasonic, "ion" and red light, and move slowly for about 10 minutes. 4. For acne, proper part of anti acne extract is on your face with an ultrasonic generator. (Note: We recommend use of colloidal flavors to achieve the best conductive ultrasonic performance) 5. Using ultrasound, "ion" add blue light, slowly, about 10 minutes. 6. Remove residual gel and take care of it thoroughly. Use EMS Instructions: 1. Use a damp towel to clean dirt, grease and cosmetics. 2. Connect wire to EMS connector using electrode label. When in use, place positive and negative electrodes of electrodes in different positions on the body (use one positive and one negative at a time) 3. Stick electrode pad on the skin to be massaged. If liner is sufficient, cover all points in a few steps. 4. Adjust strength to the lowest gears 5. Connect cord to device with plug. 6. Turn on the power (red light). 7. Select EMS massage mode: mode1/mode2/mode3/mode4/mode5. 8. Adjust strength according to your comfort (5 speed) 9. If you wish, device will automatically stop working after 10 minutes. Repeat process, open it again, repeat process 10. Recommendation: 10 minutes each time, no more than 30 minutes a day. 11. Press "level" key to adjust strength, and you can select gears that suits your needs.