Flame failure valve with inlet and outlet featuring Flare thread 5/8-18UNF Suitable for low pressure applications only (maximum BTU rating: 50,000) Compatible with gas grills, heaters, fire pits, and fireplaces with matching connections Specifications: - 600mm thermocouple with M8x1 threaded head - Bakelite knob with outer diameter of 38mm and shaft diameter of 6.1mm Installation and Operation Instructions: 1. Secure the valve to a mounting plate or board on your grill or fire pit using the head screw and flange. 2. Connect the inlet and outlet hoses to the respective sides of the valve. Ensure connections are tight to prevent gas leakage. 3. Tighten the M8 thermocouple nut securely onto the valve end. (Verify that your valve end has an 8mm thread before purchase.) 4. Ensure proper connection between the thermocouple and the valve's threaded end. 5. Turn the knob to open the gas supply and press the valve for approximately 5–10 seconds until the thermocouple tip is sufficiently heated. 6. Release the valve. If the gas shuts off upon release, check the following: - Ensure the thermocouple tip is consistently exposed to the flame. - Confirm the thermocouple is securely connected to the valve. - Verify that all hose connections at inlet and outlet are properly secured. Color: Yellow Material: Copper Package Contents: 1 x Gas Control Valve Note: The package includes only the items listed above. Other products are not included. Lighting and monitor settings may cause slight variations in the color of the item as shown in images. Measurement tolerances may vary by +/- 1–3 cm.