Features: Brand new and high quality The Manta M8P Control Board uses the 32-bit ARM Cortex-M0+ series STM32G0B1VET6 main control chip with a core frequency of 64MHz. High-performance MOSFETs are used to reduce heat generation. The power circuit on this Manta M8P integrated main control board uses TPS5450-5A, which supports DC12/24V power input; the output current of this chip is up to 5A, and the peak value can reach 6A, which perfectly supports the power supply of Raspberry Pi. The control board and core board use BTB connection methods, so other core board solutions can be selected, such as CB1. The motherboard reserves the SPI expansion interface to use Klipper firmware to connect an external acceleration sensor for acceleration compensation. The thermistor can select the pull-up resistance value through jumpers, which supports PT1000 without external modules, which is convenient for DIY use; the control board reserves a three-way four-wire fan interface, which can be used to connect a water cooling device. The MCU firmware can be upgraded via SD card, or via DFU through Klipper's make flash command; the main board reserves the switch interface, shared with VFAN6 selection. Specifications: Material: Plastic Note: 1.Please allow 1-2cm error due to manual measurement, please make sure you do not mind before you bid. 2.Due to the difference between different monitors, the picture may not reflect the actual color of the item. Package includes: 1x Control Board