High power, High brightne, High cost performance Car LED Headlight/Fog lamp Bulb Product introduction: Color temperature: 6500K Initial Power: 110W/set (55W/Bulb) Stable power: 76W/set (38W/Bulb) Luminous flux: 20000LM/set (10000LM/Bulb) Working voltage: 9-18V Working temperature: -40 -120 Protection level: IP68 Used for: headlight / fog light The above values are laboratory test values. Actual products may have very small tolerances, which is normal and If you cannot accept this, please do not purchase this product. Package Included: 2LED headlight bulb High Brightne. UP 300%. Powerful 3570 Big LED Chips. NOT COB. Compared with halogen lamps, the distance is increased by 2 times and the brightne is increased by 3 times. Bright but will not dazzle the other driver. Lights type standard, safe driving. Super Cost-effective. 1 Year Warranty Heat limits the brightne and service life of LED lights. So heat diipation is very important. Thermal conductivity copper tube + pure copper substrate, heat transfer faster. Although the heat-conduction copper tube is expensive, in order to thank the new and old customers the support and love, we have launched this cost-effective product, and you are welcome to buy it. Long Service Life. 50,000 hours. Quadruple cooling technology. Pure copper substrate, heat transfer faster. Aviation aluminum body, overall heat diipation. Intelligent temperature control driver. High-speed turbocharged fan diipate heat quickly. The service life is over 50,000 hours. Protective Design. IP68 level. Waterproof. Dustproof. Cold proof. High temperature resistance. IP68 protection level. There will be no problems in all kinds of bad weather. Easy Installation. 15 minutes to complete. You can finish it in 15 minutes. Plug and play. Save time and money. Very simple, no need to disaemble anything on our product. NOTE: 1. Please make sure the bulb model is all the same with your original bulb. 2. Please don't touch the bulb chips by hand directly. 3. If the light can't work normally, please check: (1) Whether the positive and negative poles are connected reversed; (2) The plugs are connected well or not; (3) Whether the original car plug is damaged or not; (4) Test whether the bulb works normally via original car battery or other 12V/24V power supply, confirming it's bulb problem or original car problem. 4. After installation, if the following situations occur, please purchase a dedicated CANbus decoder. (It's not our LED lights quality problem): (1) Light flickers; (2) On the dashboard, warning lights for other components turn on for no reason; (3) Radio jamming; (4) Other auxiliary lights can't work normally; (5) One side lights up normally while the other side fails to light up. 5. If high beam and low beam are reversed, please take out the bulb, rotate 180 and install again. Satisfactory Service. 100% satisfaction target.