READ THE DESCRIPTION!!!!!!!!!!!! A description of the action: AHD1080P>>>>>>>>AHD720P You receive a camera working in AHD 1080P (all cables connected). If it turns out that your radio does not support such a high resolution, cut the purple cable. The camera will then work in AHD 720P. AHD>>>>>>>>CVBS/PAL/NTSC If the camera after cutting the purple cable does not give an image, it means that your radio does not support the AHD signal. Then, cut the blue cable and the camera will work in the CVBS system, i.e. the one that supports virtually all displays. However, you need to remember that the AHD system has better quality than CVBS and I recommend everyone to work on AHD. FRONT >>>>>>>>>>BACK: The camera can be mounted at the front of the car as well as at the back thanks to the possibility of rotating the image by 180. To do this, cut the white cable A few words about AHD : The AHD system is relatively new on the market, therefore its main purpose is cooperation with the latest Android stations that support the AHD system. Note here that not every Android supports AHD, so you need to check it in the radio settings or its specifications. Factory radios in the vast majority do not work with AHD. In addition, the camera has an improved handle thanks to which it can be less visible after mounting. The power cable is 6pin with a narrow plug so you do not need to make holes with a cross section of 12mm. The camera has no assist lines and cannot be turned on in any way. parameters: Viewing angle: 170 Resolution: AHD 1080P -1960x1080 AHD720P - 1280720 CVBS/PAL/NTSC - 960x680 Light sensitivity: 0.01 LUX Cabling: RCA Waterproof: IP 68 6PIN plug Dimensions: 24mm/24mm Set contains: camera Handle Screws Cabling(6m) RCA