The moisture meter can quickly measure the moisture content of the grain. 1. It is made of PVC rubber, which is self-adhesive and leaves no sticky residue when peeled off. 2. Its waterproof substrate is resistant to wear, moisture and weather conditions and has a long service life. 3. It can be easily cut to any size suitable for any footwear, not only can prevent shoes from falling out, special surface design will play an important role in anti-slip. 4. The operation is simple. As long as the sole sticker is attached to the place where the sole touches the ground, the sole can be protected and will not damage the heel or shoes. 5. Its transparency and self-adhesion make it invisible on the soles of our shoes. It is most suitable for any heeled shoes, such as high heels, heels, shoes, etc. Please allow slight dimension error due to manual measurement. Item Type: Shoe Sole Stickers Material: pvc rubber Product color: as shown in the pictures Width: about 10 cm/3,9 inch Product weight: approx. 72-223 g/2,5-7,9 oz Instructions: 1. Prepare the necessary tools: stickers for soles, small scissors. 2. Cut the right length, just paste the front part of the high-heeled shoes that contacts the ground. In general, high-heeled shoes can be pasted 3 pairs per meter, and flat-bottomed shoes can be pasted 2 pairs (heel cannot be pasted). 3. Peel off the white release paper on the back and start pasting. When pasting, peel off the side stickers from top to bottom to squeeze the air out as much as possible. 4. Cut off the edges and hold the sole facing up while trimming for easy cutting. 5. Once glued, press firmly and several times to make it hard. Wear shoes 24 hours after application. The method of replacing the only sticker: First, use a hair dryer to heat the liner to soften the adhesive, then slowly peel it off (remember not to tear it off directly to avoid injuring the surface coating of the sole). List of packages: 1 x Shoe Sole Sticker